Andrisoft Knowledgebase
Search:     Advanced search
Browse by category:
Contact Us
Knowledgebase / NetFlow / Cisco Systems / All IN traffic passing through interface, but no OUT traffic

All IN traffic passing through interface, but no OUT traffic
Print
Email to friend
Votes: 0
  1. Run the command: 
    show ip interface brief | exclude unassigned
    to list all L3 interfaces that have assigned IP address.
  2. Check if you enabled ip route-cache cef or ip route-cache flow on all L3 interfaces.
Others in this Category
document How can I enable netflow on Cisco 3550 or Cisco 3750 devices?
document Unable to change flowmask error message on Cisco 6500
document I configured NetFlow on Cat6500, but application shows only a few MBytes, whereas it should have been several GBytes.
document When I run show ip flow top-talkers I see null destination interface. What does null interface mean?
document What means flow mask in the mls configuration?
document How can I configure netflow on Cisco?
document What are the optimal netflow aging values?
document What is difference between ip flow ingress and ip route-cache flow?
document What is diference between normal, fast and long mls aging?
document Is it possible to use the vrf interface as source of netflow packets?
document NetFlow on a Cisco 4500 series. Do I need a NetFlow services card?
document Can I use a bridged IP traffic NetFlow on PFC3A?
document What is netflow table capacity on Cisco?
document WARNING: TCAM request associate message... What is it mean?
document What means TCAM Utilization and ICAM Utilization?


Powered by KBPublisher (Knowledge base software)