Andrisoft Knowledgebase
Search:     Advanced search
Browse by category:
Contact Us
Knowledgebase / NetFlow / Cisco Systems / Is it possible to use the vrf interface as source of netflow packets?

Is it possible to use the vrf interface as source of netflow packets?
Print
Email to friend
Votes: 0
NetFlow VRF Export:
- Allow the export of flow records within a VRF.
- Valid for both SCTP * and UDP export.
Router(config)# ip flow-export destination 10.1.1.2 2000 vrf testvrf <sctp|udp>
Router(config-flow-cache)# export destination 10.1.1.2 2000 vrf testvrf <sctp|udp>

where testvrf is a VRF name.
Introduced in 12.4(4)T on the low-end routers.

* SCTP is not supported by WANGuard at this time.
Others in this Category
document How can I enable netflow on Cisco 3550 or Cisco 3750 devices?
document Unable to change flowmask error message on Cisco 6500
document I configured NetFlow on Cat6500, but application shows only a few MBytes, whereas it should have been several GBytes.
document When I run show ip flow top-talkers I see null destination interface. What does null interface mean?
document What means flow mask in the mls configuration?
document How can I configure netflow on Cisco?
document All IN traffic passing through interface, but no OUT traffic
document What are the optimal netflow aging values?
document What is difference between ip flow ingress and ip route-cache flow?
document What is diference between normal, fast and long mls aging?
document NetFlow on a Cisco 4500 series. Do I need a NetFlow services card?
document Can I use a bridged IP traffic NetFlow on PFC3A?
document What is netflow table capacity on Cisco?
document WARNING: TCAM request associate message... What is it mean?
document What means TCAM Utilization and ICAM Utilization?


Powered by KBPublisher (Knowledge base software)